If the conveyor fails, such as motor burning, mechanical transmission part damage, belt or chain pulled off, belt slip, etc., the magnetic switch in the accident sensor SG installed on the passive parts of the conveyor cannot be closed or cannot be closed at the normal speed, then the control system will be in accordance with the reverse time characteristic after a certain delay, the speed protection circuit will take effect, so as to execute part of the action. Cut off the power supply to the motor to avoid a wider accident
(2) Mine belt conveyor temperature protection.
When the temperature of the belt conveyor is over the limit due to friction between the drum and the belt, the detection device (transmitter) installed closely to the drum will send out an over temperature signal. After receiving the signal, the receiver will delay by 3s to make part of the operation, cut off the power supply of the motor, and the conveyor will stop automatically to protect the temperature.
(3) Coal level protection under the head of mine belt conveyor.
If the coal is piled under the head of a conveyor due to an accident that cannot be operated or the coal gangue is blocked or the coal bunker is stopped due to the full coal bunker, then the coal level sensor DL at the corresponding position contacts the coal and the coal level protection circuit acts immediately to make the next conveyor stop immediately. At this time, the working face continues to produce coal, and the tail of the conveyor will pile coal one by one, and make the corresponding one stop until the transfer machine automatically stops running.
(4) Mine belt conveyor coal bunker coal level protection.
When the coal bunker cannot discharge coal because there is no empty car, the coal level will gradually rise. When the coal level rises to the high electrode, the coal level protection action will be taken. Starting from the first belt conveyor, each conveyor will stop in turn due to the coal pile at the tail
(5) Mine belt conveyor emergency stop and lock.
There is an emergency stop latching switch in the lower right corner of the front side of the control box. By rotating the switch left and right, the emergency stop latching can be implemented in this station or the front conveyor
(6) Mine belt conveyor deviation protection.
If the belt conveyor runs off during operation, the belt edge that deviates from the normal running track will pull down the sensor rod installed next to the conveyor and immediately send out an alarm signal. The maintenance time of the alarm signal can be adjusted in the range of 3-30s according to the need. If timely measures can be taken to remove the deviation during the alarm period, the conveyor can continue to operate normally.
(7) stopover protection of mine belt conveyor at any point midway.
If you need to stop at any point along the conveyor, you should switch the corresponding position to the middle stop position, belt conveyor will stop immediately. If you need to turn it on again, reset the switch first, and then press the signal switch to signal.
(8) Smoke protection for mine belt conveyor.
When smoke occurs due to belt friction and other reasons in the roadway, the smoke sensor suspended in the roadway will play a role in sending out alarm sound, and after 3s delay, it will protect the circuit, cut off the power supply of the motor and play a role in smoke protection.
Stone Conveyor Belt: Enhancing Efficiency and Productivity in Material Handling
Optimizing Operations with PE Conveyor Belts: Durability, Efficiency, and Versatility
Exploring the Efficiency and Versatility of Light Conveyor Belts
