1. The use of suitable smooth oil, especially the input power of the reducer motor is greater than 11KW, should be injected with load gear oil. Pay attention to check the smooth oil, hydraulic oil, coolant, oil level and quality, and pay attention to check the sealing performance of the machine. Too much oil was found in the view, and the reason should be analyzed. At the same time, the smoothness of each smoothing point should be enhanced. It is recommended to add grease to the smooth spots weekly during run-in (except for special requirements).
2. Fast wear speed: because of the influence of the new conveyor belt
parts processing, installation, debugging and other factors, the contact area of the cooperation surface is small, and the torque distance is large.
3. Operation fault: because of the structure and performance of the conveying equipment (especially the new operator) is not enough to understand, it is easy to form faults due to the operation fault, and even the formation of mechanical problems and safety problems.
4. Poor smoothness: Because the cooperation gap of the newly assembled parts is small, because of the assembly and other reasons, the smooth oil (fat) is not easy to form a uniform oil film on the surface of the conflict, to prevent wear and tear. Thus, the smoothing power is reduced, which leads to the abnormal wear of parts in the early stage.
5. Loosening: the newly fabricated parts have the deviation of geometric shape and cooperative scale.
6. Leakage: because the parts are loose. Vibration and heat resistant conveyor belt heating, conveyor belt sealing surface and pipe joints, part of the casting and other defects are difficult to find in the installation and debugging, but because of the vibration and impact in the operation process, the leakage (leakage) oil is exposed. As a result, leakage may occasionally occur during run-in.
7. Adhere to the reducer motor clean, timely adjustment.
8. At the end of the running in period, the machine should be forced to protect, check and adjust, and pay attention to the replacement of oil.
In short, the application and protection requirements of heat resistant conveyor belt running in period, only the protection and protection of heat resistant conveyor belt running in period, will reduce the production of early problems, extend the service life, improve the production power, bring you more benefits.