What are the causes and solutions of the skid of the conveyor belt with large inclination Angle

What are the causes and solutions of the skid of the conveyor belt with large inclination Angle? Here I will share with you, I hope my introduction can better help you.

At present, the conveyor belt is widely used in industrial production, but it is inevitable to encounter skid in the process of using the conveyor belt. The following conveyor belt manufacturers give you a brief introduction to the causes of skid of the conveyor belt with large inclination Angle and what are the solutions?

1. The initial tension is too small. The belt tension leaving the roller is not enough to cause the conveyor belt to slip. This usually happens at startup. The solution is to adjust the tensioning device and increase the initial tension.

2, start too fast will also form a skid. At this point, it can be started slowly, and it can be started after two clicks, and it can also effectively overcome the skidding phenomenon.

3. The tail roller bearing or the upper and lower idler bearing is damaged. The reason for the damage is that the tail floats and sinks too much, which is repaired and replaced in time, thus increasing resistance and causing skidding.

4. The friction force between the driving drum and the conveyor belt does not meet the requirements, and the sliding occurs. The main reason is that there is water on the conveyor belt or the environment is wet. The solution is to add some pine powder to the roller. But do not use hand casting, but to use the blast equipment to blow in, so as to avoid personal accidents.

5. If the load on the conveyor belt is too large, it will slip if it exceeds the capacity of the motor. Skidding protects the motor, but for handling, this is a skidding accident.

Through the manufacturer to introduce you to the cause of large inclination conveyor belt skid and solutions to what do you understand? I hope our introduction can help you better.