Strengthening the maintenance and regular maintenance inspection of belt conveyor machinery
can prolong the service life of the pattern conveyor belt. Then in the maintenance and maintenance of belt conveyor machinery, we should pay attention to the following parts?
Belt conveyor bearing point: bearing point is easy damaged parts in the pattern conveyor belt, need to pay attention to factors include: idle, material particle size, direction of impact, hosting run are all factors need to be aware of, belt conveying machinery lagged mouth feed slot width should be big enough, and distance pattern conveyor belt has a certain distance, shoulds not be too tall and too short. Loading materials on the Angle point in the running direction of the decorative pattern conveyor belt will increase the wear of the conveyor belt, and the material weight and height will increase the impact force on the conveyor belt. If the material deviates from the center of the conveyor belt, it will lead to the deviation of the conveyor belt, and also lead to the damage and wear of the edge glue of the conveyor belt.
Than big, sharp edges and material in operation will produce certain impact, will be cut and wear conveyor belt, in order to reduce this kind of situation, decorative pattern conveyor belt manufacturers recommended first put powder material on the conveyor belt, and then put a big block material in pattern conveyor belt, or shattered after the big materials to the decorative pattern on the conveyor belt.
The belt machine is set up a guide groove, the guide groove is also another reason for the wear of the conveyor belt surface, the guide groove can not be too close to the conveyor belt, should be part of the distance, otherwise it will lead to the surface wear of the conveyor belt. The fixed part of the loading point device shall not contact with the surface of the tape, nor shall the material be stuck in the guide groove.