In the belt conveyor, the conveyor belt occupies a very important position. It is not only a traction component, but also a bearing component. It is expensive, accounting for about 30 to 50 percent of the total belt conveyor cost. Once a belt is thinned due to wear, it will suffer from reduced strength, shortened life, belt offset and other problems. According to the theory of consumption, several main wear modes are analyzed, and some maintenance measures are put forward.
Wear between the feed tank and the
conveyor belt, close contact between the feed tank and the conveyor belt. Its design and installation have a great influence on the wear of the conveyor belt, which is the main way to wear the conveyor belt. When supplying materials, it will affect the conveyor belt, especially when the Angle between the material and the direction of the conveyor belt is greater than or equal to 90 degrees, it will seriously affect the wear of the conveyor belt; In order to avoid material scattering, the contact surface between the guide plate and the conveyor belt is too tight, resulting in the wear of the conveyor belt.
Hard materials containing long impurities in the data can stick to the conveyor port and wear or scratch the conveyor belt. In order to reduce the wear of the conveyor belt at the feed port, the structural design of the feed port should meet the following conditions: The conveyor belt and the conveyor belt should run in the same direction. During the feeding process, the material moves at almost the same speed as the conveyor belt.
The equivalent free falling height of materials on the conveyor belt is less than 1m, so the impact force on the conveyor belt should be as small as possible. The feed chute is equipped with a screen so that the fine material first falls onto the conveyor belt, providing a buffer for the anisomes. The reasonable design of chute and guide groove makes the material fall into the conveyor belt continuously; The baffle width of the guide groove Narrows along the direction of the conveyor belt. In addition, the guide groove should be extended to the speed of the data to reach the speed of the belt.
The above is the relevant information brought to you by the conveyor belt manufacturer. If you want to know more about the conveyor belt, the conveyor belt, the pattern conveyor belt, welcome to consult us!
Features of Telescopic Conveyors
Mine belt conveyor belt is good for mining
Lightweight conveyor belts and heavy conveyor belts
Advantages of the V type belt conveyor
