The frequency of use of conveyor belt
is becoming higher and higher, and production and life are becoming more and more inseparable from conveyor belt. However, conveyor belt is a kind of consumable, which is easy to damage, and then increases the cost of enterprises. The damage of the conveyor belt is an absolute event, which is inevitable. What we can do is to extend the service life of the conveyor belt as far as possible, so what are the use skills to extend the service life of the conveyor belt? The following Xiaobian for you to make an introduction.
First, the pattern conveyor belt manufacturers guide you to correct a small part of the damage in time. In general, we can often use three methods, one is part of the hot vulcanization, need to be equipped with a conveyor belt vulcanization machine can be used; Second, partial cold pouring, this method is the use of liquid polymer composite correction data, after up to 10 hours of curing; Third, part of the cold adhesive, repair by repair strip, cold adhesive, etc., time is short, economic and simple, but the effect is not as good as hot vulcanization.
Two, the pattern conveyor belt manufacturers guide you to reasonably adjust the hopper of the conveyor belt. Conveyor belt hopper reasonable improvement can effectively solve the transfer of the conveyor belt, in general foreign body after can increase the ability of more than two times, and the reasonable hopper can improve big foreign body card placed in the funnel wall and the production of conveyor belt between the situation, it is a way to reduce the belt tearing method caused by foreign material, It is effective to prevent the early damage of the conveyor belt.
Three, keep a suitable distance between the hopper and the guide apron, reduce the occurrence of material stuck between the conveyor belt and the apron, and then stick to the wear of the conveyor belt. For some large drop hopper should be added buffer baffle.